Inmotion V11- Improved cooling system
£1.00
Tax included
In stock
9
pcs
Improved cooling system for Inmotion V11
Nozzle that directs air from the fan directly to the motherboard housing.
The cooling tube/nozzle is made on 3D printer, color black looking very good and is very durable
The nozzle, when mounted on the back of fan of the front lamp, directs the air stream directly to the rear wall of the motherboard housing, significantly improving heat dissipation from MOSFET transistors.
Highly recommended be EUC riders.
It is brand new Nozzle and was visually checked and pass our quality inspection, but bear in mind this is 3D print so the surface is not perfectly flat.
The assembly of the nozzle does not require any modifications to the inmotion V11. It is very easy and takes about a minute. See the guide below
Mounting method:
Unscrew the two opposite screws from the four securing the fan
Place the nozzle on back of fan
Gently screw the nozzle in this place use the same screws
Will be dispatched within 24 h with free Royal Mail 2nd Class.
“Warning: It is illegal to ride electric scooters on public roads, pavements, or cycle paths. They are intended only for use on private land with the owner’s permission.
9 Items
Specific References
